Starting and stopping the InterFormNG2 Server

Starting and stopping the InterFormNG2 Server

The InterFormNG servers are running in the IFORMNG2 subsystem. You simply stop or start the servers by stopping or starting the subsystem from the menu or via these commands:

 

ENDSBS IFORMNG2

 

STRSBS IFORMNG2/IFORMNG2

 

It is advisable to setup start of the IFORMNG2 subsystem in the IPL program in QSTRUPPGM - remember to add a MONMSG CPF0000 to ensure that the IPL program can run even this subsystem cannot be started.

    • Related Articles

    • Starting the Designer

      Starting the Designer This section covers the use of the InterFormNG2 designer. For installation you should refer to Installation and upgrade. You can start the designer in two ways: 1. By clicking the 'Designer' icon in the top ribbon e.g. from the ...

    • Intersigning server

      If you want to add written signatures to your output PDF files, then you need to configure the signing server below. Details are covered in the section covering Intersigning. In order to setup Intersigning, you first need to sign in as described ...

    • DigitalSign Server

      If you want to use InterFormNG2 to digitally sign invoices as required in Portugal, then you should use the workflow component, DigitalSign cloud PDF signing. Before you can use this component you need however need to setup a DigitalSign Server in ...

    • Global email server setup

      You need to setup a global email server order to be able to send system emails from InterFormNG2 e.g. to reset emails. Notice a similar email configuration for each tenant is normally also required. In order to setup the global email server, you ...

    • To email server

      The advanced output workflow component, to email server is able to send out an email, that you have already configured via one of the tenant email servers. The component has these parameters: Hold email If you activate this option, then the email ...